The basic structure of Shaking table

Shaker is a widely used mineral processing equipment. Its basic structure is divided into bed, headboard and frame of three main parts. A typical structure shown in Figure 29Shaking table. (1) bed, the bed can be wood, glass, steel, metal (such as aluminum, cast iron) and other materials. The shape of the common are rectangular, trapezoid and rhombus. Along the vertical surface of the bed parallel to the nail bed of many (also known to complex) or engraved with grooves, since the transmission side of the bed on the lower side and a slash on the tip off. Bed frame from the rack supporting or lifting. Shaking the bed is tilted, the horizontal was 1.5 to 5 degrees to the mine by the end of tilt to the right side, so that ore from the tank and rinse tank to give into the water on the bed surface to form a thin layer of slope water. Top right of the bed to the mine shafts, the total length of the bed length of approximately 1 / 3 to 1 / 4; in to the side of open mine shafts have many holes, so that the pulp evenly distributed in the bed surface. And is connected to the mine shafts red sink, accounting for the total length of the bed 2 / 3 3 / 4, to the sink side is also open many holes, so that flushing can be uniform along the vertical surface to bed in. Valve in the tank is also equipped with a number, used to regulate water distribution along the length of the bed.
(2) bed (transmission), driven by the motor, through the rod connecting the bed to make the bed for asymmetry along the vertical reciprocating motion. Into the bed in front, the speed from slow to fast and then quickly stopped; in to the back, the speed rapidly from zero to the maximum, then slowly reduced to zero group. Bed have a vertical differential movement, so that the bed surface of mineral particles can move one-way operation. Forward to the concentrate side haulage haulage, otherwise known as reverse haulage.
(3) rack or hanging body, the supporting means for the bed-and suspended located. Bed type is located directly connected with the bracket and the bracket has a slope adjustment device for adjusting the horizontal bed slope. Hanging rope to the bed with a hanging shelf, hanging in the air bed. Adjusted by adjusting the slope of the elastic rope to adjust.